LICENSE: Downloading the latest HASP driver [27703]

This article applies to:

E-Prime 3.0

E-Prime 2.0

E-Prime 1.x

Detail

E-Prime requires Sentinel HASP drivers in order for your license to work properly. To download the latest GUI HASP driver, you need to visit the following page:

Sentinel HASP/LDK Windows GUI Run-time Installer

Navigate to the webpage, download the file, and install the latest Sentinel HASP/LDK driver.

NOTE: The E-Prime 2.0 installer is incompatible with GUI HASP Driver Version 8.31 or later (ERROR: HASP Driver Version 8.31 or later causes E-Prime 2.0 installation error 2753 [39149]). You can update to this version after the E-Prime 2.0 installation is complete.

NOTE: A reboot of the machine may be required after installation and is recommended after any installation affecting the HASP driver.

The latest Command Line HASP driver, can be found on the following page:

Sentinel HASP/LDK Windows Command Line Run-time Installer

NOTE: If deploying E-Prime 3.0 Update 3 via msi or lowercase setup.exe, you must use a command line installer to install the Provisional License. To do so, copy the ep3lm.v2c, haspds_windows.dll, and haspvlib_50978.dll from the Support folder of the extracted EP3.0.3.214.exe to the location of the Command Line Run-time Installer (haspdinst.exe). You can verify the Provisional License is installed by navigating to http://localhost:1947/_int_/devices.html and checking that a HASP SL AdminMode key exists with a Location of Local and a Vendor Number of 50978.

See Also:

INSTALL: E-Prime 3.0 Prerequisites required for installation [26947]

INSTALL: E-Prime 2.0 Prerequisites required for installation [19325]

FAQ: How do I register for support and access downloads? [27523]