INFO: Connecting third-party switches to Chronos [30394]

This article applies to:

Chronos

For example, a SPST Normally Open switch would use the following diagram:

R1 should be 10k-100k. Technically, you could wire this without a resistor if you wired the switch "backwards". But it is best practice to use the resistor.

For example, a SPST switch can be found below:

 
If you have any questions or concerns about your configuration, please contact Product Service & Support.

See Also:
INFO: Assembling a Chronos Custom Expansion Kit [27526]
INFO: Chronos Warning: Driving Induction Load [25077]
INFO: Powering Devices With Chronos [29142]