This article applies to:
Warning: Improper use of Chronos may void your warranty.
In general, PST reccomends the use of a resistor to Ground.
For example, a SPST Normally Open switch would use the following diagram:
R1 should be 10k-100k. Technically, you could wire this without a resistor if you wired the switch "backwards". But it is best practice to use the resistor.
For example, a SPST switch can be found below:
If you have any questions or concerns about your configuration, please contact Product Service & Support.
INFO: Assembling a Chronos Custom Expansion Kit 
INFO: Chronos Warning: Driving Induction Load 
INFO: Powering Devices With Chronos